Industrial Resources
Bandsaw dismantlers, trim saws and a lead board remover.
The name identifies the machines. We are not Industrial Resources and do not sell for them.
Models you see used

Industrial Resources Rapid Cut II
- Kind
- High-volume bandsaw dismantler
- Specs
- 15 HP direct drive, 4,200 ft/min, 22 ft 10 in blade, 64 in table
- Output
- 800 to 1,000 pallets a shift, one operator, maker’s claim
- Source
- Pallet Enterprise dismantler guide, July 2025

Industrial Resources Wolverine II
- Kind
- Bandsaw dismantler
- Specs
- 15 HP; single-phase and variable speed options; 23 ft 9 in blade; 64 in table
- Output
- 400 to 600 pallets a shift, maker’s claim
- Source
- Pallet Enterprise dismantler guide, July 2025

Industrial Resources Quick Cut
- Kind
- Trim saw
- Specs
- 16 in nail buster blade, 10 HP; single-phase option
- Output
- up to 4,200 cuts an hour, maker’s claim
- Source
- Pallet Enterprise trim saw guide, April 2024

Industrial Resources Clipper
- Kind
- Lead board remover
- Specs
- 6 blades, 5 HP
- Source
- Surplus Record, Pallet Nailers and Pallet Equipment
Photographs show the kind of machine, not the model or a machine we hold. Where the maker publishes no output figure for a model, we leave that line out rather than guess.
Buying or selling a used Industrial Resources
Industrial Resources makes the fastest bandsaw dismantler in Pallet Enterprise’s 2025 guide by the numbers given: the Rapid Cut II, with a 15 HP direct-drive motor running the blade at 4,200 feet a minute, rated by the maker at 800 to 1,000 pallets a shift with one operator. The Wolverine II is the steadier machine, rated at 400 to 600, and it is one of the few with a single-phase option, which matters to small shops.
The Quick Cut trim saw runs a 16 inch nail buster blade on a 10 HP motor, also with a single-phase option, and the maker rates it at up to 4,200 cuts an hour. A Clipper lead board remover, a six-blade machine on 5 HP, was on a dealer’s list with Request Price.
On a used Rapid Cut or Wolverine, look at the air spring or pneumatic tensioning, the large pneumatic drive and idler tires, the table lift and the guides.
Industrial Resources builds for the recycler’s first two steps: taking the pallet apart and squaring the boards. The Clipper is less common, a lead board remover that takes off the end deck boards, and a shop that recovers lead boards for resale or rebuild will know why it wants one. The Wolverine II’s single-phase option makes it one of the few full-size dismantlers a shop without three-phase can run.
If you are selling one, send the model, the motor and phase, the table width, the tensioning type and photos of the drive tires and guides.
Tensioning is where Industrial Resources machines differ from others: air spring or pneumatic tensioning, large pneumatic drive and idler tires. Ask a seller when the air bags and tires were last replaced, and check that the tension holds pressure overnight. The Quick Cut trim saw, up to 4,200 cuts an hour by the maker’s figure, has a single-phase option too. Wolverine and Rapid Cut owners often upgrade rather than replace. Tire wear shows as tracking trouble.