Used machines for pallet shops, by make and model.

Find me a machine
Menu

Kiln-Direct

Heat-treating and drying kilns for pallets, sized in GMA pallets.

The name identifies the machines. We are not Kiln-Direct and do not sell for them.

Models you see used

End- or side-loaded kilns, the kind of machine the Kiln-Direct heat-treating kilns, 12 standard models is

Kiln-Direct heat-treating kilns, 12 standard models

Kind
End- or side-loaded kilns
Specs
300 to 800 GMA pallets; LP, natural gas or biomass; stainless steel chambers
Output
Heat treat 1 to 6 hours in most cases; drying 8 to 24 hours, maker’s claim
Source
Pallet Enterprise heat-treating guide, July 2025
Conversion unit, the kind of machine the Kiln-Direct reefer van conversion is

Kiln-Direct reefer van conversion

Kind
Conversion unit
Specs
Converts a reefer van into a kiln
Source
Pallet Enterprise heat-treating guide, July 2025

Photographs show the kind of machine, not the model or a machine we hold. Where the maker publishes no output figure for a model, we leave that line out rather than guess.

Buying or selling a used Kiln-Direct

Kiln-Direct builds heat-treating kilns for pallet shops. The 2025 heat-treating guide gives it 12 standard models holding 300 to 800 GMA pallets, end- or side-loaded, fired by LP gas, natural gas or biomass and wood waste. It quotes heat-treating cycles of one to six hours in most cases and drying cycles of 8 to 24 hours, with stainless steel chambers, a touchscreen with onscreen troubleshooting, wireless record keeping, phone status alerts and heat recovery on venting. It also lists a unit that converts a reefer van.

Biomass firing matters to a pallet shop: the scrap from the grinder can heat the kiln. If you are buying a used kiln, ask which fuel it was set up for and what changing it would take.

Any used kiln has to be certified again at its new site through an ALSC-accredited inspection agency before you stamp a pallet. Ask for the probes, the recording software and the records the agency approved.

A Kiln-Direct kiln is how a pallet shop becomes an export shop: heat-treat to ISPM 15, stamp the pallets, and sell to customers who ship overseas. Its standard models hold 300 to 800 GMA pallets per charge, and the maker states heat-treat times of 1 to 6 hours in most cases. The reefer van conversion is a smaller, cheaper way in for shops that heat-treat now and then.

Selling one? Send the model, the fuel, the burner, the controller and recorder, and the inspection agency it was certified with.

Kiln-Direct’s kilns are end- or side-loaded, which decides how a forklift fills them and how the building around them is laid out. The maker lists wireless record keeping and touchscreen controls; ask whether those, and any software licence, transfer with a used kiln.

Ask what fuel the burner was set up for, and confirm the fuel train, regulators and the gas supply at the new site with a licensed fitter before you buy. Insulated panels, doors, fans and baffles should all be inspected for damage after dismantling and shipping.

Fans, motors, thermocouples and recorder calibrations deserve a service log; buyers ask for it, inspectors expect it, and its absence lowers the value. Ductwork, venting and condensate drainage need planning at the destination too. Shipping crates, cranes and permits add up.

The same machines from other makers

Kilns
No other maker of kilns has a page here yet.