Used machines for pallet shops, by make and model.

Find me a machine
Menu
A manual pallet chop saw over a steel roller infeed table with pine stringers beside it

Pallet chop saws

A pallet chop saw is a cut-off saw on a swing arm or a pop-up arbor that cuts boards and stringers to length one cut at a time. Blades in the trade guide run from a 14 inch manual saw to Baker’s 36 inch saw, and it is often the first saw a small recycling shop buys before it can justify a power-feed trim saw.

Chop and cut-off saws in the trim saw guide
Maker and modelKindPowerSize and capacityMaker’s output claim
Universal manual chop sawManual14 in blade (10 in optional)Board and stringer cut-off[1]
Universal 18 in manual chop sawManual, four stopsSingle-phase motor available18 in blade[1]
Universal standard chop saw with conveyorWith conveyorElectric; gas option22 in blade, cuts 6 x 12[1]
Universal Robo-ChopPop-up cut-off60 in outfeed tableabout 2 seconds a cycle[1]
Baker chop sawWith roll cases20, 26 or 36 in blade10 ft infeed, 5 ft outfeed roll case[1]
Saifan SF6060Pushing chop saw[1]

A dash means the maker’s page or the listing gave no figure for that column.

Output figures are the makers’ own claims as the source prints them, not our measurements.

  1. Pallet Enterprise trim saw guide, April 2024, read Nov 15, 2026

Published asks

Chop saws: asking prices as listed
Maker and modelMachineYear and conditionListed fromAsk
Brewco pallet sawPallet saw, 167 in conveyor, 30 HP, three-phaseYear and condition not listedEuclid, OH, Surplus Record$2,719

Asks, not sales: what each seller listed when we read the page on 15 Nov 2026. We are not the seller of these machines, and a listed machine may since have sold.

Where it fits in a small shop

A chop saw cuts lumber and recovered stringers to length, takes out broken sections, and squares the odd board the dismantler left long. It is slower than a power-feed trim saw because a person handles every cut, but it costs less, takes less floor and can run on single-phase or, on Universal’s conveyor model, gas.

Blade size decides what it cuts. A 14 or 18 inch saw handles deck boards and 2 x 4 stringers; the 22 inch conveyor saw takes 6 x 12 material, and Baker’s 36 inch saw is for heavy timber and skids.

Checking a used chop saw

Check the arm pivot for play, the blade guard and its return, and the brake if it has one. Run it and listen to the arbor bearings. On an air-activated saw, look for leaks at the cylinder and the foot valve. Measure the roll cases and stops, and ask whether the stops are still square to the blade.

The Brewco pallet saw in the table below, listed with a 30 HP motor on three-phase, is a reminder to read the nameplate: a big motor needs the power to match. When your volume outgrows one cut at a time, the power-feed trim saws are the next step.

Selling a chop saw

Chop saws are cheap enough that sellers often scrap them. Don’t: small shops want them. Send the blade size, the motor, whether it is manual or air, and whether a conveyor or stops come with it.