Guides for buying pallet machinery
Written for people starting or growing a pallet shop: which machines to buy first, what to check on a used one, and how the choices compare. The figures in them are the makers’ claims and published asks, each with its source.

Starting a pallet recycling business
The machines a new recycling shop buys first, in order.

What it costs to start
Published asks for the first machines, and why the old $30,000 figure is out of date.

Starting a new-pallet shop
Resaw, trim saw, notcher and nailer: how building new differs from recycling.

Is pallet recycling profitable?
What decides a recycler’s margins: cores, labor per pallet and machine output.

Checking a used dismantler
Blade guides, wheels and bearings, table lift, motor and power.

Checking a used nailer
Guns or drivers, fixtures, flipper and stacker, controls and pallet sizes.

Bulk or collated nailers
Costlier machine and cheaper nails, or the reverse.

Certifying a used kiln
The ALSC agency, heat probes and the 56 °C for 30 minutes rule.

Grinder or shredder?
Whole pallets, nails, output and power: which a small yard needs.
Start with the guide closest to the decision in front of you. If you are opening a shop, the start-up guides set out the machines in buying order and the cost guide shows what they were listed at. If a seller has offered you a machine, the checklists say what to look at before you pay. If you are choosing between two kinds of machine, the comparison guides set them side by side, with a table.
Every figure in these guides names its source: Pallet Enterprise’s buyer’s guides for dismantlers, nailers, trim saws, grinders and kilns; USDA APHIS for heat treatment; Surplus Record for published asks, read in November 2026. Where a number is a maker’s claim, we say so.
New guides follow the questions people send us; suggest a topic by email. Corrections are welcome, especially from operators.
| What should I buy first? | Recycling start-up or new-pallet shop |
|---|---|
| What will it cost? | Published asks by machine |
| Will it pay? | Margins: cores, labor, output, scrap |
| Is this used machine any good? | Dismantler checklist, nailer checklist |
| Which kind should I choose? | Bulk or collated, grinder or shredder |
| Can I move a kiln? | Recertifying a used kiln |
Read enough and ready to look? Find me a machine or sell my machine.