
Leverage pallet dismantlers
A leverage dismantler pries the deck boards off a pallet with air-powered levers, so each board comes off at full thickness with its nails still in it. Bronco’s machine runs at 100 PSI and is rated by the maker at 60 to 80 pallets an hour, or 400 to 600 a day for one operator.
| Maker and model | Kind | Power | Size and capacity | Maker’s output claim |
|---|---|---|---|---|
| Bronco Pallet Systems leverage dismantler | Leverage, one operator | 100 PSI compressed air | Adjusts to pallet size; safety bar across the back | 60 to 80 an hour, 400 to 600 a day[1] |
Output figures are the makers’ own claims as the source prints them, not our measurements.
- Pallet Enterprise dismantler guide, July 2025, read Nov 15, 2026
Prices
Why a shop picks one over a bandsaw
There is no blade. A bandsaw machine shaves a little off each board where the band runs and needs blades sharpened or replaced; a leverage machine keeps the board whole. Shops that sell recovered lumber by thickness, or that rebuild with the same boards, like that.
The trade-off is the nails. Every board comes off with nail shanks in it, so somebody punches or pulls them before the board goes to the trim saw. The rated output is also lower than the faster bandsaw machines, which are rated up to 1,000 pallets a shift.
It runs on air, so the question is the compressor, not three-phase. That suits a shop on single-phase power that already runs nail guns. Bronco fits air couplers for pneumatic nailers on the machine, so it can double as a repair station.
Checking a used one
Run it on a pallet. Listen for leaks at the cylinders, valves and hoses, and watch whether the levers come back square. Look at the pivot pins and the hold-down for play. Ask what compressor and air line it was run on, and how many pallets a day it actually did. Bronco states a five-year warranty on parts for new machines; on a used one, ask whether any of it transfers, and assume it does not unless the seller shows you otherwise.
If a leverage machine is not quite right for you, the bandsaw models are the usual alternative and the dismantler overview compares all four kinds.
Air supply and placement
Bronco’s figure is 100 PSI, so the compressor matters as much as the machine. Size it for the leverage dismantler plus every nail gun on the same line, and put a dryer and regulator near the machine; wet air wears cylinders. Leverage machines are light enough to move with a pallet jack or forklift, which makes them a common first machine in a rented building where you cannot bolt anything down. Boards come off with nails in, so a punch-out table or a debris conveyor belongs right beside it.