
Pallet dismantler blades
Pallet dismantler blades are long bandsaw blades, cut to the length of one machine’s wheels, that run flat across the table and cut the nails between boards and stringers. The blade length is what you need to know first, and the dismantler guide gives it for several machines, from 21 ft 9 in on the PRS Spartan to 23 ft 9 in on the Industrial Resources Wolverine II.
| Machine | Kind | Blade speed or power | Blade | Blade life, as claimed |
|---|---|---|---|---|
| PRS Spartan | Bandsaw dismantler | 2,200 SFPM | 21 ft 9 in blade | [1] |
| Industrial Resources Rapid Cut II | Bandsaw dismantler | 4,200 ft/min | 22 ft 10 in blade | [1] |
| Industrial Resources Wolverine II | Bandsaw dismantler | Quick blade change | 23 ft 9 in blade | [1] |
| Cam-Wood 1AM-010-2G | Gas bandsaw dismantler | 13 HP | 251 x 1-1/4 in blade | [2] |
| Wood-Mizer PD200 | Bi-metal blade | 2,200 ft/min | Length by table width | up to 1,500 pallets a blade[1] |
| Smart Products dismantlers | Blade guide bearings | 2,600 or 3,700 ft/min | 52 or 64 in base | 1,200 to 1,500 pallets a blade[1] |
A dash means the maker’s page or the listing gave no figure for that column.
Output figures are the makers’ own claims as the source prints them, not our measurements.
- Pallet Enterprise dismantler guide, July 2025, read Nov 15, 2026
- Surplus Record, Pallet Nailers and Pallet Equipment, read Nov 15, 2026
Prices
We do not show blade prices: none were published where we read.
Ordering the right blade
Send us the machine’s maker and model, the blade length and width from the old blade or the manual, and whether it ran bi-metal or carbon steel. Length is not negotiable: a blade even a little long or short will not tension on the wheels. Width matters too; the Cam-Wood listing gives 1-1/4 inch.
Tell us how many pallets you get from a blade now. Makers state 1,200 to 1,500 pallets a blade on the Smart Products and Wood-Mizer machines. If yours is well under that, look at the guides, the tension and the wheel tires before you blame the blade.
Why blades wear out early
Dirt and grit in recovered pallets dull teeth, and hitting hardware or a stone in a block chips them. Worn guide bearings let the blade wander and heat up, and low tension lets it wave in the cut. A blade that cracks at the gullets is usually fatiguing from too much tension or a wheel that is out of round.
Blades are on the same request as machines. The blade machines are on the bandsaw dismantler page, and the checklist covers guides and wheels.
Blade stock
A shop that stops when its last blade breaks loses a shift. Keep enough on the shelf to cover the time a new order takes to arrive, and store them coiled and dry. When you buy a used dismantler, ask for any blades that come with it: they are worth having even if you switch brands later.