Used machines for pallet shops, by make and model.

Find me a machine
Menu
The blade guide bearings and upper wheel of a pallet dismantler bandsaw with its guard open

Wood-Mizer Pallet Hawg PD200

The Wood-Mizer Pallet Hawg PD200 is a bandsaw pallet dismantler built for one or two operators, on a 10 HP electric motor or a 19 HP gas engine. Pallet Enterprise’s 2025 guide gives it about 400 pallets a shift with one operator, a 2,200 feet-per-minute bi-metal blade and up to 1,500 dismantled pallets a blade, all as the maker states them.

The Pallet Hawg PD200 as the guide describes it
Maker and modelKindPowerSize and capacityMaker’s output claim
Wood-Mizer PD200, electricBandsaw, one or two operators10 HP electric, 2,200 ft/min60, 72, 84 or 96 in tableabout 400 a shift, one operator[1]
Wood-Mizer PD200, gasBandsaw, one or two operators19 HP gasolineTwo 27 in bias ply tires, forklift pocketsabout 400 a shift, one operator[1]

Output figures are the makers’ own claims as the source prints them, not our measurements.

  1. Pallet Enterprise dismantler guide, July 2025, read Nov 15, 2026

Published asks

Wood-Mizer Pallet Hawg PD200: asking prices as listed
Maker and modelMachineYear and conditionListed fromAsk
Wood-Mizer pallet dismantlerBandsaw pallet dismantler, listed as barely usedusedUxbridge, ON, Surplus Record$10,878

Asks, not sales: what each seller listed when we read the page on 15 Nov 2026. We are not the seller of these machines, and a listed machine may since have sold.

Who it suits

The gas version is why people search for it. A shop on single-phase power, or a yard with no building at all, can run a Pallet Hawg where a 15 HP three-phase machine would need new service from the power company. The wide table options, up to 96 inches, take skids and oversize pallets that a 52 inch machine will not.

It is not the fastest machine in the guide. At about 400 a shift it sits at the low end, against 800 to 1,000 for the high-volume bandsaws. For a start-up tearing down a few hundred a day, that is often enough.

What to check on a used Pallet Hawg

The table lift is pneumatic with 5-1/2 inches of travel; run it full height and back with a pallet on it. Blade tension is mechanical, so check the screw and the wheel alignment. On the gas model, start it cold and ask for engine hours. Look at the two 27 inch tires if it has been towed between sites.

Ask how many pallets the shop gets from one blade, against the maker’s up to 1,500. A shop getting far fewer usually has guide or tension trouble. The used dismantler checklist has the rest; other models are on the bandsaw page.

Gas or electric, used

The gas Pallet Hawg is the one start-ups ask for, because it runs with no grid service at all. On a gas machine ask for the engine hours, when the oil and plugs were last changed, and whether it starts cold. On the electric version ask what voltage and phase it was wired for. On either, ask which table width it has: 60 to 96 inches covers most pallet sizes, but a shop running big pallets needs the longer tables.

Wood-Mizer is better known for portable sawmills, and the Pallet Hawg shares that thinking: simple, mobile, and easy for one or two people to run. Spare bi-metal bands, a sharpener and a setter keep it running; ask whether they come with it. Hours matter less than care.