Used machines for pallet shops, by make and model.

Find me a machine
Menu
The open stainless steel doors of a heat-treating kiln with new pallets stacked inside

Pallet heat-treating kilns

A pallet heat-treating kiln heats loads of pallets until the wood core reaches 56 °C for at least 30 minutes, which is the treatment export pallets need for the ISPM 15 mark. Kilns are sized by how many GMA pallets they hold, from a few hundred to a few thousand, and a used one has to be certified again at its new site through an ALSC-accredited inspection agency.

Kiln makers in the 2025 heat-treating guide, with stated capacity
Maker and modelKindPowerSize and capacityMaker’s output claim
Kiln-Direct, 12 standard modelsEnd- or side-loadedLP, natural gas or biomass300 to 800 GMA palletsHeat treat 1 to 6 hours in most cases[1]
Nyle Dry KilnsContainer and chamber packagesPropane or natural gas, indirect350 to 660 GMA palletsAbout 3 hours to heat treat[1]
SII Dry KilnsChambersNatural gas, propane, steam, hot water600 to 2,400 GMA pallets2 to 3 hours[1]
Nova Dry KilnHot-water basedGas, wood waste or electricTruckload, half or quarter load4 to 5 hours[1]
Millwood EZ-FloPressurized forced airElectric22 GMA pallets240 pallets an hour heat treating[1]

Output figures are the makers’ own claims as the source prints them, not our measurements.

  1. Pallet Enterprise heat-treating guide, July 2025, read Nov 15, 2026

Prices

Kilns are sold to a site and a fuel. We show no asks for them; tell us what you need and we will ask.

The rule a kiln has to meet

USDA APHIS says heat-treated wood packaging must reach a core temperature of 56 °C for at least 30 minutes, and that producers must enroll with an inspection agency accredited by the American Lumber Standard Committee. The kiln is only part of it: the agency checks your probes, your records and your process before you can stamp.

So a used kiln is not certified when it arrives. It is a box with burners and controls that has to be set up, probed and approved again where it now stands. Our kiln certification guide goes through the steps.

Choosing and checking one

Start with capacity in GMA pallets and your fuel: Kiln-Direct quotes LP, natural gas or biomass; Nyle indirect gas; SII steam and hot water as well. Then cycle time, because a 2 to 3 hour cycle and a 6 hour one give very different daily counts from the same box.

On a used kiln, look at the chamber walls and roof for corrosion and damaged insulation, the doors and seals, the burner or heat exchanger, the fans and the controls and data logging. Ask whether the probes and recording software come with it, and how it will be taken apart and moved.

Moving a kiln

Most pallet kilns are built as panels or containers that can be taken down and moved, but the burner, controls and probes have to be set up and tested again at the new site, and the inspection agency has to certify it there. Get the drawings, the burner manual and the probe records from the seller, and plan the gas or power service for the new site before you buy.