Go Fast
Notchers and multi-head trim saws for cut stock.
The name identifies the machines. We are not Go Fast and do not sell for them.
Models you see used

Go Fast 2NX
- Kind
- Double head notcher
- Specs
- Listed 2025
- Source
- Surplus Record, Pallet Nailers and Pallet Equipment

Go Fast NXL
- Kind
- Single notcher
- Specs
- On a dealer’s used list, stock-numbered, no price
- Source
- A pallet machinery dealer’s used equipment page

Go Fast MET-20
- Kind
- Multi-head trim saw
- Specs
- 2 to 7 heads, 10 HP a head, 20 in carbide blades; stock up to 20 ft long, 12 in wide, 5-1/2 in thick
- Output
- up to 45 cuts a minute, maker’s claim
- Source
- Pallet Enterprise trim saw guide, April 2024
Photographs show the kind of machine, not the model or a machine we hold. Where the maker publishes no output figure for a model, we leave that line out rather than guess.
Published asks for Go Fast
| Maker and model | Machine | Year and condition | Listed from | Ask |
|---|---|---|---|---|
| Go Fast 2NX | Double head pallet notcher | 2025 | Uxbridge, ON, Surplus Record | $18,129 |
Asks, not sales: what each seller listed when we read the page on 15 Nov 2026. We are not the seller of these machines, and a listed machine may since have sold.
Buying or selling a used Go Fast
Go Fast machines sit in new-pallet plants more than recycling shops. The MET-20 is a multi-head trim saw: two to seven heads, each with a 10 HP motor and a 20 inch carbide-tipped blade, cutting lumber up to 20 feet long and 5-1/2 inches thick. That is a cut-stock machine, turning long lumber into stringers and deck boards to length, and the maker claims up to 45 cuts a minute.
The notchers are where Go Fast meets recyclers. A 2025 2NX double head notcher was listed at $18,129 in November 2026, the highest notcher ask we read. A Go Fast NXL single notcher was on a dealer’s used list at the same time, stock-numbered and without a price.
On a used MET-20, ask how many heads it has and whether they can be added, check each head’s motor and blade, and look at the lug chain. On a notcher, the heads, the teeth and the clamp.
A MET-20 belongs in a plant that buys lumber in long lengths and cuts its own stringers and deck boards, ahead of the notcher and the nailer. Its value depends on how many heads it carries and how its stops are set, so a buyer will ask about both. A Go Fast notcher sits right after it, putting fork notches into the stringers it cuts.
If you are selling one, send the head count, the motors, the blade size, the lug chain’s condition, and the stock lengths it was set up to cut.
Lug chains, sprockets and stop settings decide how a multi-head trimmer runs, and they wear quietly. On a used MET-20, run a bundle through it and measure the lengths that come out; if they wander, look at the chain and the stops before the motors. A notcher from the same maker sits easily beside it on the floor, fed from the trimmer’s out-feed.