Used machines for pallet shops, by make and model.

Find me a machine
Menu
Close view of carbide insert teeth seated around a notcher head

Pallet notcher teeth

Notcher teeth are the carbide tips or indexable inserts screwed or brazed onto a notcher head, and they are the part of a notcher that wears fastest. Indexable inserts can be turned to a fresh edge or swapped one by one; brazed carbide teeth go back to a saw shop for re-tipping and grinding.

What to measure on the teeth you have
What to noteWhat it meansHow to tellThenTip
Insert styleIndexable or brazedScrewed in or brazed onCount them on the headThe Cam-Wood 1AM-1180-G lists 40 insert-tip cutters[1]
Insert sizeLength, width, thicknessMeasure with calipersNote any marking on the insertSend a photo beside a ruler
Screw or clampThread and head typeTorx or hexOrder spares with insertsSeats must be clean and flat
EdgesHow many usable edgesTwo or four on most insertsTurn before replacingTrack hours per edge

From the sources below.

  1. Surplus Record, Pallet Nailers and Pallet Equipment, read Nov 15, 2026

Prices

We do not show tooth prices: none were published where we read.

Turning, replacing or re-tipping

With indexable inserts, turn each insert to its next edge when the cut gets rough, and replace it when every edge is used or one is chipped. Clean the seat before you put a new one in; a chip under an insert makes it sit proud and break. With brazed teeth, send the head to a saw shop; do not run it with missing teeth, because the next tooth takes double the load.

Recovered stringers carry nails, grit and the odd staple. A notcher fed only new lumber keeps its edges much longer than one notching recycled stringers, so compare your wear against shops doing the same work.

What to send us

The notcher’s maker and model, the head diameter, how many teeth it carries, the insert size or a photo of one beside a ruler with any marking visible, and how many sets you want. If you are not sure whether the head itself is worn, see the notcher heads page.

For the machines themselves, see single head and double head notchers.

How many to keep

Count the inserts on your head, then keep at least a full set and a box of screws on the shelf. Teeth chip on nails left in stringers, so a recycler goes through them faster than a shop notching new lumber. Re-tipping brazed carbide is specialist work; indexable inserts you can turn and change yourself with a driver. Store spare inserts in their packets, away from moisture and loose steel, so the edges arrive sharp. Torque screws evenly when you seat inserts. Dull inserts burn wood and overload motors.